1.Clean the dent with a clean wet cloth;
2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue;
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adhere (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter)
6. Align the 2 in 1 dent removel T bar and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen.
8. Clean the repaired place with a clean wet cloth