Material: steel & Alum.

Allows the crank seal to be replaced without dismantling the crank case saving your time and costs.

Do not worry about scraping the crank surface. Universal use covering a wide range of cars with oilseals between 27 mm and 58 mm in diameter.

Use the existing bolt in the vehicle for installation.

Screw-type adapter to fit the centering.

The blue seal adapters are made of aluminum to preventthe damage of crank.

Note: Do not attempt to use this tool by force. Some cam seals have screws to prevent remove.

Contents:

Wire

Three strong galvanised steel wires braided to form one wire.

2 x Wire gripping handles

Feed the wire through the hole in the wedge shaft.  Loop it through the hole at the top of the shaft.  Then back into the handle.  Pressing the wedge back into the handle, the wire is held.

Windshield removal tool

Cuts the vinyl adhesive compound around the windshield.

Wire feeder tool

Designed for easy and flexible insertion of wire through polyurethane, allowing speedy removal of bonded windshield.

Trim pad remover

Place the tool under the edge of the door upholstery panel and insert it into the fastener as far as possible, then simply pry up.

Windshield molding release tool

Specification:

6 x Blue adapters

5 x large silver adapters

7 x Small silver adapters

Puller

Full instructions with diagrams included

For use with oil seals between 27 ~ 58mm diameter